PROJECTOR INSTALLATION

1. Suggested hanging height is measured from the center of the painting at 57” from the ground. If the painting is above furniture then the height will vary. 

2. Ceiling mount and the projector should be installed 4.5’ to 5’ away from the wall on which the painting is hung on. Depending on ceiling height (and especially if you have high ceilings), please try and have the projector to sit roughly 1’ above the height of the painting from the floor. It is ok if it is higher so long as you have full projection coverage of the painting when the projector is turned on. Please see the below diagram.

Note: If using the recommended projector mount - you can change the height of the projector by using the included extension, or by purchasing a 1.5” diameter NPT pipe extension from the included list, or any hardware store that sells 1.5” diameter threaded pipe - cut to the desired length. 

3. Ensure that power is run to the projector with a plug extension to allow for at least two power connections, this is to ensure that both the projector and the MediaPlayer both are powered at the same time and to avoid running additional cables from the wall to the projector site.

4. Make sure that when the Projector is turned on, it completely covers both the painting and the frame in projection light. If the projector is hung upside down, please refer to the manual about how to ensure that the image is flipped correctly, this is done typically using the remote that comes with the projector and can be found in the settings on the menu. It is recommended to do this step before installation otherwise you will have to read the menu upside down.

5. Please refer now to the MediaPlayer Installation Guide.